Protemp Temporary Solar LED Site Lighting

Every ProTemp is fitted with smart Passive Infrared Sensor (PIR) to optimise power usage in the unit. A bright light is activated when the area is entered by a vehicle or person. When the area is unused this ‘smart eye’ technology switches off to save battery usage and minimise light pollution.

The Prolectric ProTemp has been proven in operation at a number of major construction sites across the UK. Working with our partner manufacturing suppliers we have developed and tested the unit, so we can be confident it will operate reliably even during dark days and winter conditions.

The ProTemp can be moved into position quickly and easily with a forklift or telehandler to provide high-quality bright light that will continue reliably even through dark days and winter conditions. For contractors and events organisers, the ProTemp is a ‘setup and forget’ asset that does not need to be refuelled or serviced.

With no mains power, the ProTemp dispenses with the need for a contractor to dig trenches, install trunking or cables and saves significantly on groundworking and installation costs.

As an alternative to temporary diesel lighting, the ProTemp offers a clean, low-carbon lighting solution that requires minimal maintenance. Available for hire or purchase, it is straightforward to switch to the ProTemp.

We will work with you to design a solar lighting solution specific to your site and deliver the right number of ProTemp lights to your site anywhere in the UK. Prolectric offers a lighting design service to ensure you have the optimum temporary lighting configuration for your site.

Yes, we’re able to offer you access to our Street Lighting portals. A master and then gateways are added to the panels including a sim card for connectivity. The portal will give access to each panel and light connected to the specific setup network. You can see battery soc, generation, lights on or off. You can also put the lights on a time schedule away from their usual UK settings

Our lights can be used on all unadopted roads, but not on adopted roads.

Adopted roads are looked after by councils and maintained accordingly. They also like to use a control system with all street lighting and have it on a set program. Due to the way our PIR’s work they are not effective enough to work on highways due to the speed of vehicles. By the time the car gets detected by the PIR, the light comes on after the car has passed the light.

Yes, we have been installing lights in the UK since 2011 and we have developed the software and knowledge to ensure the lights work consistently up and down the UK.

The solar street lights are used across both small and large sites in both commercial and residential settings including housing estates, parks, car parks, seafronts, campuses, hospital estates and military bases.

The latest panel technology means that even on a cloudy day, power will still be generated. The battery has capacity for around 5 consecutive days of n0 solar yield, to cover even the worst periods of UK weather.

2,500 cycles. However, this is not 2,500 days.  Majority of the year (roughly 9 months), the lights do not go thru a full cycle every day. They are expected therefore to last between 4 – 7 years dependent the level and number of full discharges.

Our AE6 provides coverage of up to 687m² at a level down to 0.4Lux. This measurement is on the ground and will be on the outer most edge of the light spread. It could be over 10 lux directly below the light but will dissipate the further you go from it. When a lighting design is created it overlaps with light spread from the other lights to give a uniformity.

Solar lights are entirely off-grid and require no cables or trenches.

Yes, all of the settings are customisable. The lights will illuminate at dusk. The light intensity at both triggered and no triggered mode can be adjusted based on customer requirements. Additionally the lights can be set to turn off at a particular time if in a residential area.